This topic collection provides the information to install
the 7316-TF4 18.5-Inch
Flat Panel Rack-Mounted Monitor and Keyboard console.
The console unit occupies 1U of mounting space in a rack. To install
the console unit in the rack, complete the steps in the following
sections. Removing the rack doors and side panels, and removing the
rack devices that are above and below where you want to install the
console unit, might make installation easier.
See the documentation that comes with your rack for additional
information.
Guidelines for rack mounting the console unit:
- Elevated operating ambient - If installed in a closed or multi-unit
rack assembly, the operating ambient temperature of the rack environment
might be greater than room ambient. Therefore, consideration should
be given to installing the equipment in an environment compatible
with the maximum ambient temperature (Tma) specified by the manufacturer.
- Reduced air flow - Installation of the equipment in a rack should
be such that the amount of air flow required for safe operation of
the equipment is not compromised.
- Mechanical loading - Mounting of the equipment in the rack should
be such that a hazardous condition is not achieved due to uneven mechanical
loading.
- Circuit overloading - Consideration should be given to the connection
of the equipment to the supply circuit and the effect that overloading
of the circuits might have on overcurrent protection and supply wiring.
Appropriate consideration of equipment nameplate ratings should be
used when addressing this concern.
- Reliable earthing - Reliable earthing of rack-mounted equipment
should be maintained. Particular attention should be given to supply
connections other than direct connections to the branch circuit (for
example, use of power strips).
DANGER
When working on or around the system,
observe the following precautions:
Electrical voltage and current
from power, telephone, and communication cables are hazardous. To
avoid a shock hazard:
- If IBM supplied the power cord(s), connect
power to this unit only with the IBM provided
power cord. Do not use the IBM provided power
cord for any other product.
- Do not open or service any power supply assembly.
- Do not connect or disconnect any cables or perform installation,
maintenance, or reconfiguration of this product during an electrical
storm.
- The product might be equipped with multiple power cords. To remove
all hazardous voltages, disconnect all power cords.
- Connect all power cords to a properly wired and grounded electrical
outlet. Ensure that the outlet supplies proper voltage and phase
rotation according to the system rating plate.
- Connect any equipment that will be attached to this product to
properly wired outlets.
- When possible, use one hand only to connect or disconnect signal
cables.
- Never turn on any equipment when there is evidence of fire, water,
or structural damage.
- Do not attempt to switch on power to the machine until all possible
unsafe conditions are corrected.
- Assume that an electrical safety hazard is present. Perform all
continuity, grounding, and power checks specified during the subsystem
installation procedures to ensure that the machine meets safety requirements.
- Do not continue with the inspection if any unsafe conditions are
present.
- Disconnect the attached power cords, telecommunications systems,
networks, and modems before you open the device covers, unless instructed
otherwise in the installation and configuration procedures.
- Connect and disconnect cables as described in the following procedures
when installing, moving, or opening covers on this product or attached
devices.
To Disconnect:
- Turn off everything (unless instructed otherwise).
- Remove the power cords from the outlets.
- Remove the signal cables from the connectors.
- Remove all cables from the devices.
To Connect:
- Turn off everything (unless instructed otherwise).
- Attach all cables to the devices.
- Attach the signal cables to the connectors.
- Attach the power cords to the outlets.
- Turn on the devices.
Sharp edges, corners and joints may be present in and around
the system. Use care when handling equipment to avoid cuts, scrapes
and pinching.
(D005)
CAUTION:
This product is equipped with a 3-wire (two conductors
and ground) power cable and plug. Use this power cable with a properly
grounded electrical outlet to avoid electrical shock. C018
